Switching Off; Maintenance And Cleaning; Warranty And Service Information - Parkside PDBN 6.3 A1 Bedienungs- Und Sicherheitshinweise

Operation / Maintenance and cleaning / Warranty and service information
z Switching OFF
Release the trigger arm
„
1
the air nibbler
Disconnect the device from the com-
„
pressed air supply after completing work.
Note: First detach the compressed air hose
from the compressed air source, and then
remove the compressed air hose from the
device. This will prevent a situation where
the compressed air hose whips around
uncontrollably.
z Maintenance and cleaning
If the machine is to enjoy a long service life
and operate without problems, it is important
that the following maintenance instructions
are followed.
The air nibbler 1
„
regularly (after every 3-4 operating
hours) if it is to operate flawlessly at all
times.
Note: The air nibbler
serviced and overhauled for proper function
and for compliance with the safety require-
ments. Improper and wrong operation may
cause failures and damage to the device.
ATTENTION: DISCONNECT THE DEVICE
FROM THE COMPRESSED AIR SUPPLY
PRIOR TO MAINTENANCE WORK!
1. Keep the pneumatic devices clean.
Clean the air nibbler
intervals using a moist cloth and a little
liquid soap.
2. Turn over the air nibbler
compressed air connection
upwards, and apply a few drops of
pneumatic equipment or motor oil
SAE 10-20 into the compressed air
connection 4 of the air nibbler
16 GB
3 to switch OFF
.
must be lubricated
1 must be regularly
1 at regular
1
so that the
4 points
1 .
RECONNECT THE DEVICE TO THE
COMPRESSED AIR SUPPLY.
Press the trigger arm
„
oil more evenly. Hold a cloth or absor-
bent paper towel in front of the exhaust
air openings 6 , and let the device run in
idle mode for a few seconds.
ATTENTION! EXCESS OIL IS BLOWN
OUT. KEEP THE DISCHARGE HOLE
AWAY FROM PERSONS AND OBJECTS.
Speed and vibrations must be checked
„
every time after maintenance and care.
1
The air nibbler
„
dry rooms. Make sure that no moisture
can enter inside the air nibbler
Before all maintenance, clean the device
„
of hazardous substances that have de-
posited on it (during work processes).
Avoid all skin contact with these sub-
stances. Hazardous dust coming into
contact with skin may cause serious
dermatitis. Dust that is generated or
raised during maintenance work can be
breathed in.
Please ensure that the safety of your
„
device is guaranteed by mean of regular
maintenance operations.
Maintenance must be performed by
„
properly trained personnel only.
Ensure that device repairs always use
„
original replacement parts and are
performed by a qualified technician.
This ensures that the device is safe to
operate at all times.
z Warranty and service
information
Warranty from Creative Marketing &
Consulting GmbH
Dear Customer,
The warranty for this equipment is 3 years
3
to distribute the
should be stored in
1 .