Maintenance And Cleaning; Disposal - Parkside PDNB 6.3 B2 Originalbetriebsanleitung

Maintenance and cleaning

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
ATTENTION!
► Before maintenance, clean off any hazardous
substances that may (due to working processes)
have accumulated on the tool . Avoid all skin
contact with these substances . If the skin
comes into contact with hazardous dusts, this
can lead to severe dermatitis .
► The dust and vapours produced by using the
tool can be hazardous to health (e .g . cause
cancer, birth defects, asthma and/or dermati-
tis); it is essential to carry out a risk assessment
in respect of these risks and to implement cor-
responding regulatory mechanisms .
NOTE
► To ensure correct functioning and long-term
durability of the tool, pay attention to the
following points:
■ Before each use, check the tool and the acces-
sory tool . Also check the speed and vibration
levels .
■ After each use, check the speed and vibration
level of the tool . During maintenance work,
wear appropriate protective clothing (ear muffs,
dust mask, protective goggles and protective
gloves) .
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning .
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk .
In doubt, contact the Service Centre .
■ Use only accessories and supplies of the sizes
and types recommended by the manufacturer .
■ Clean the tool only with a soft, dry cloth or with
compressed air .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
■ Store the tool in a clean and dry location . Make
sure that no moisture can get into the tool .
■ 18 │ GB │ IE

Disposal

The packaging consists of environmen-
tally friendly material . It can be dis-
posed of in local recycling containers .
Do not dispose of the tool in the normal
domestic waste!
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out tool .
Dispose of the packaging in an
environmentally friendly manner .
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary .
The packaging material is labelled with
abbreviations (a) and numbers (b) with
the following meanings:
1–7: plastics,
20–22: paper and cardboard,
80–98: composites .
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product .
The product is recyclable, subject to
extended producer responsibility and
is collected separately .
Dispose of lubricants and cleaning agents in an
environmentally friendly manner . Observe the legal
regulations .
■ Dispose of lubricant residues at a disposal
point . Do not allow lubricants to get into drains
or watercourses . Do not allow them to get into
the subsoil/soil . Make sure you use a suitable
mat/surface . Dispose of lubricants in accord-
ance with official regulations .
Dispose of contaminated maintenance material
and consumables at a collection point provided for
this purpose .
PDNB 6.3 B2