Herunterladen Inhalt Inhalt Diese Seite drucken

Unrolling The Hose; Rolling Up The Hose; Adjusting The Hose Stopper; Maintenance And Cleaning - Parkside 327372_1904 Originalbetriebsanleitung

Druckluft-schlauchtrommel
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 44
The locking device generates a clicking noise
when rolling up and unrolling . This is not a fault .
If the noise changes after using the equipment
numerous times and/or if there are problems
with the mechanism, seek expert assistance or
contact customer service .

Unrolling the hose

Pull the compressed air hose
the drum housing to the desired working length
for the pneumatic tool . If you release the
compressed air hose
locking device engages at this length .

Rolling up the hose

A short pull on the compressed air hose
releases the lock .
Make sure that the compressed air hose
back into the drum housing
manner .

Adjusting the hose stopper

The position of the hose stopper
adjusted and interrupts the rolling up of the
compressed air hose
will need a Phillips screwdriver (not included) to
adjust the hose stopper
Undo the fastening screws
screwdriver (see fig . D) .
Slide the hose stopper
compressed air hose
Retighten the fastening screws
36 
GB │ MT
carefully out of
after a click, the
in a controlled
can be
to the desired length . You
.
with the Phillips
along the
to the desired position .
.

Maintenance and cleaning

NOTE
The compressed air hose reel must be serviced
regularly and overhauled to ensure proper
functioning and compliance with safety require­
ments . Improper and incorrect operation can
lead to failures and damage to the appliance .
Never use harsh and/or abrasive cleaning
agents or solvents . These could damage the
plastic parts of the compressed air hose reel .
Never allow water to get inside the compressed
air hose reel . Make sure that the housing and the
compressed air hose remain free of dust and dirt .
To ensure this is the case, wipe the compressed
air hose reel regularly with a clean cloth .
Before returning the compressed air hose to the
rolls
housing, clean the compressed air hose for
further use if possible .
Clean the compressed air hose reel and the
hose with a damp cloth and a little soap at
regular intervals .
PDST 10 B3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis