Information On The Use Of A Mobile Device With The Cockpit App - Ottobock C-Leg 3C88-3 Gebrauchsanweisung

CAUTION
Safety mode cannot be deactivated
Falling due to unexpected product behaviour because of changed damping behaviour.
► If you cannot deactivate safety mode by recharging the battery, a permanent malfunction
has occurred.
► Do not continue using the defective product.
► The product must be inspected by an authorised Ottobock Service Centre. The prosthet­
ist is your contact person.
CAUTION
Safety signal occurs (ongoing vibration)
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Observe the warning/error signals (see Page 66).
► Do not continue using the product after the safety signal has been emitted.
► The product must be inspected by an authorised Ottobock Service Centre. The prosthet­
ist is your contact person.

4.9 Information on the use of a mobile device with the cockpit app

CAUTION
Improper use of the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
► Make sure you have been instructed in the proper use of the device with the cockpit app.
CAUTION
Independently applied changes or modifications made to the device
Falling due to altered damping behaviour as a result of unexpected switching into MyMode.
► Do not make any independent changes to the hardware of the device.
► Do not make any independent changes to the software/firmware of the device which are
not included in the update function of the software/firmware.
CAUTION
Improper mode switching with the device
Falling due to unexpected product behaviour because of changed damping behaviour.
Ensure that you stand securely during all switching processes.
►
► Verify the changed damping characteristics after switching and observe the feedback
from the acoustic signal emitter (beeper) and the display on the device.
► Switch back to basic mode once the activities in MyMode have been completed.
NOTICE
Destruction of the device due to falling or penetration of water
Malfunction of the device.
► If necessary, let the device dry at room temperature (at least 1 day).
► If you can no longer switch from MyMode back to basic mode, the only way to switch the
component back to basic mode is by using a motion pattern (see Page 58) or plug­
ging/unplugging the battery charger.
Ottobock | 47