TERMA SKT 1 Gebrauchsanweisung Seite 52

FIL-PILOTE INTERFACE
Selected versions of SKT 2 are equipped with a FIL PILOTE interface which
enables remote heating control through an external controller which conforms with
Signal
FP Command
FP-COMFORT
FP-ECO
FP-AF
FP-STOP
Device performance in accordance with FIL PILOTE is interrupted if the dryer mode
is on ( 2h button). After dryer mode has expired, the device will go back to the
FIL PILOTE commands.
Reaction of the Controller
Heating in accordance with current
setting
Reduction of settings by 1 level (if
current setting equals 1, device will turn
itself off)
No heating, anti-freeze function is active
Heating mode and anti-freeze functions
are both off
TROUBLESHOOTING
Problem Possible cause
Device is not turned on
Device is connected to
electricity, no diodes are
on, heating element
Problem with connection
does not heat
or power supply
Heating element does Possible incorrect
not heat, both diodes are installation of controller
flashing alternately on the heating element
Device heats although it Possible electronics
has been turned off the damage
q button
In any other situations, disconnect the device from electricity, wait for the
radiator to cool down and turn it back on again. If the problem persists, please
contact your local Distributor.
Problem solution
Turn the device on with
the q button
Check the connection of
the power supply wire.
Check if the voltage is
correct
Check if the controller
has been correctly
connected with the
heating element (casing
of the controller should
completely cover the
head of the heating
element)
Disconnect the device
completely from
electricity and wait until it
cools down, then turn it
back on again