TERMA SKT 1 Gebrauchsanweisung Seite 44

Complete SKT unit contains Terma-SPLIT
heating element and controller for it.
Depending on the model of the controller, it
can also be completed by a remote wall-
mounted programmer.
1. SPLIT heating element
2. Heating element
3. Heating element head
4. Controller
5. Clamping screw
6. Power cord (versions –PB, PB (FP6),
–PW)
7. Masking cover for X-type connection
(versions –M, -MS, available only for
SKT 1)
ELECTRIC radiator:
1. Radiator powered by the heating element only, not connected to the central
heating system.
2. Water, water with anti-freezing agent or the right type of oil should be used as
a heating medium – possibility of installation and correct use is conditioned by
meeting manufacturer's requirements on the radiator and heating element.
3. Filling the radiator with too much liquid leads to exceeding of acceptable
pressure and damaging of the radiator or heating element. If You are filling the
radiator yourself, please act strictly according to the below instructions.
4. Other methods of correct filling of radiator can be found on www.termaheat.pl.
5. Do not assemble or disassemble the device by twisting the casing of the
controller. Please use the right key for this purpose!
6. Heating element should not be fitted horizontally or turned downwards.
Tools required for installation of heating element unit
– Allen key 1.5 (included)
– spanner no 24
– screwdriver (for –M and –MS versions)
Installation of the heating element unit
WARNING! The device must not be connected to electricity during
installation. Unplug the device prior to installation.
5
WARNING! Please take every precaution when filling the radiator in order to avoid
1
being burnt by hot liquid!
6
2
PB/SW
3
4
7
M/MS
1
1. Insert heating element (1) into the threaded opening at the bottom end of the
collector.
2. Twist the head of the heating element with a spanner no 24.
3. Position the element in such a way so that the indent in the head connection
(A) was directed towards you or sideways.
4. Put the radiator in an oblique position to make sure that the upper collector
opening is in the highest point !!!The radiator must not be rested on the heating
element controller or any other parts of the connection at any time!!!
5. Fill the radiator with the heating medium.
6
4
A
5
2 3
A
max.
B
340º
8 9