Standard Spare Parts; Accessories; Environmental Protection; Minimising Wear And Preventing Damage - Stihl RT 4082 Gebrauchsanleitung

● Support the trailer at the front so that it
cannot tilt up due to the weight of the
machine.
● Use a suitable lifter or suitable and
stable loading ramps of sufficient width
for loading the machine.
● Position the loading ramps safely and
secure – observe the wheel base and
track width of the ride-on mower.
( 21.)
● Ensure an even distribution of the load
on trailers.
● After loading, select the lowest cutting
level. ( 12.6)
● Stop the engine. ( 12.3)
● Push the machine fully forward until the
bumper contacts the front wall of the
trailer or vehicle.
● Engage the parking brake. (
● Close the fuel cock. (
● Fasten the front bumper of the machine
to the front wall of the trailer or vehicle
using suitable fastening material
(straps, ropes, etc.), apply forward
tension and secure.
● Place additional wedges (not included
in standard equipment) at the wheels to
prevent the machine from inadvertently
rolling away.

16. Standard spare parts

Mowing blade:
6140 702 0100
Blade fastening screw:
9010 345 2430
Spring washer:
0000 702 6600
108

17. Accessories

Additional accessories are available for
the machine.
Further information is available from your
STIHL specialist dealer, on the internet
(www.stihl.com) or in the
STIHL catalogue.
8.10)
14.15)

18. Environmental protection

Lawn clippings should be
composted and not disposed of
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately and in
an environmentally friendly manner,
recyclable waste can be re-used. For this
reason, the machine should be disposed
of for recycling at the end of its useful life.
Waste products such as used oil (engine
oil, gearbox oil), fuel and batteries must
always be disposed of properly. Observe
local regulations.
Remove the battery before disposing of
the machine.
The fastening elements for the
mowing blade (e.g. blade fastening
screw) must be replaced when
replacing the blade, i.e. when
installing the blade. Spare parts are
available from a STIHL specialist
dealer.
For safety reasons, only
accessories approved by STIHL
may be used with the machine.
Do not dispose of the battery with
domestic waste, but hand it in to a
specialist dealer or at a hazardous waste
collection point.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
STIHL recommends STIHL specialist
dealers.
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
lawn mower with driver's seat and
combustion engine (STIHL RT)
STIHL assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your STIHL
machine:
1. Wearing parts
Some parts of the STIHL machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Grass catcher box
– V-belt
– Battery
0478 193 9904 A - EN