Changing The Engine Oil; Fuel Cock; Removing The Steering Column Cover; Installing The Steering Column Cover - Stihl RT 4082 Gebrauchsanleitung

● Check the filling level as per the engine
instruction manual – top up the engine
oil if necessary. ( 14.14)

14.14 Changing the engine oil

Danger of burns due to hot
engine oil!
Allow the engine to cool down
before topping up the engine oil or
before changing the oil.
Information regarding the engine oil and oil
capacity can be found in the engine
instruction manual.
Dispose of used oil in conformance with
statutory requirements.
Oil change interval:
The recommended oil change intervals
can be found in the engine instruction
manual.
Draining the engine oil:
● Stop the engine and allow it to cool
down (warm to the touch). (
● Engage the parking brake. (
● Remove the discharge chute. (
● Open the storage compartment.
( 14.11)
● Drain the engine oil via the oil drain
valve (above the right-hand rear wheel)
as per the engine instruction manual.
Topping up engine oil:
● Top up the engine oil as per the engine
instruction manual – use a suitable
funnel and hose (not included in
standard equipment).
● Close the storage compartment
( 14.11) and install the discharge
chute. ( 14.6)
0478 193 9904 A - EN

14.15 Fuel cock

The flow of fuel in the fuel line is
enabled or interrupted by
opening or closing the fuel cock.
The fuel cock is located behind
the left-hand rear wheel.
● Stop the engine. (
● Engage the parking brake. (
12.3)
8.10)
14.5)
The fuel cock (1) is opened and closed by
turning control valve (2).
14.16 Removing the steering column
cover
● Stop the engine. (
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
12.3)
8.10)
Press both retaining lugs (1) inwards
slightly and hold. Pull steering column
cover (2) downwards and remove.
14.17 Installing the steering column
cover
● Stop the engine. (
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
12.3)
8.10)
12.3)
8.10)
103