Changing The Wheels - Stihl RT 4082 Gebrauchsanleitung

Remove the cap from valve (1).
● Inflate the tyres to the following tyre
pressures using a suitable air pump
with pressure gauge.
Front tyres:
0,9 - 1,2 bar
Rear tyres:
0,7 - 1,0 bar

14.10 Changing the wheels

In the case of damage (holes, cracks, cuts,
etc.) to the wheels, remove the damaged
wheel and take it to a specialised dealer.
Lifting and supporting the machine
Risk of injury!
Always secure the machine against
rolling away before lifting.
Bear in mind the heavy weight of
the machine when lifting it (see
section "Technical specifications").
( 21.)
If necessary, raise the machine with
the help of a second person or
using a jack (not included in the
standard equipment).
The brake only acts on the rear
wheels, suitable measures against
rolling away must therefore
additionally be taken when lifting
the rear axle.
Avoid damage to the machine!
When supporting, ensure that only
the axle or the rear panel of the
machine contacts the support.
Only lift the machine at suitable
components (e.g. frame, bumper,
rims, axle). Never lift or support the
machine at plastic parts.
● Park the machine on firm and level
ground.
0478 193 9904 A - EN
● Stop the engine. ( 12.3)
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
Front axle:
A > 200 mm
Rear axle:
B > 120 mm
Removing a wheel
8.10)
Remove the cap (1). Remove the retaining
ring (2) using a screwdriver.
Pull the large washer (3) together with the
wheel (4) off the wheel axle.
When removing the rear wheels,
ensure that the couplers (feather
keys) are not lost.
Installing a wheel
Before installing the rear wheels,
ensure that a coupler (feather key)
is located in the groove of the wheel
axle on both sides.
The following points must be observed
before installing the wheels:
● Remove dirt from the wheel axle.
● Lightly coat the wheel axle with grease
before installation.
99