Combustion Engine; Gearbox; Storage; Extended Periods Of Inoperation (E.g. Winter Break) - Stihl RT 4082 Gebrauchsanleitung

Using a grease gun (not included in
standard equipment), inject grease on
both sides via grease nipples (1) until
small amounts of grease escape from the
steering knuckles.
● Remove escaping lubricating grease.
● Remove support for the front axle.

14.23 Combustion engine

Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the
engine oil and air filter regularly.

14.24 Gearbox

For the user, the gearbox is maintenance-
free.
During the inspections of the machine by
the specialist dealer, the required
maintenance operations are performed on
the gearbox.
0478 193 9904 A - EN

14.25 Storage

● Store the machine in a dry and dust-
free room out of reach of children and
unauthorised persons.
● Any machine faults must be remedied
prior to storage in order to maintain a
safe operating condition.
● Close the fuel cock. ( 14.15)
● Remove the ignition key and keep in a
place where no unauthorised persons,
especially children, can access it.
14.26 Extended periods of inoperation
(e.g. winter break)
● Carefully clean all external parts of the
engine and machine, in particular the
cooling ribs.
● Thoroughly lubricate/grease all moving
parts.
● Remove the fuel from the fuel tank and
carburettor (e.g. by running empty).
● Engage the parking brake. (
● Observe the information in the engine
instruction manual.
● Perform an engine oil change (engine
instruction manual). ( 14.14)
● Disconnect the battery. (
● Store the battery safely in fully-charged
condition, in a cool and dry room.
14.27 Following storage for extended
periods (e.g. over winter)
● Check the battery voltage. If the
minimum voltage is not achieved, fully
recharge the battery using a battery
charger before installation.
Minimum voltage: 11,5 V
● Insert and connect the battery.
( 14.20)
● Check the tyre pressures. (
● Check the fuel level and top up if
necessary.
● Perform an engine oil change if
necessary. (
● Check the engine oil level and top up if
necessary. (

15. Transport

Risk of injury!
Before transporting, carefully read
and observe the section "For your
8.10)
safety", in particular the subsection
"Transporting the ride-on mower".
( 4.), (
Drive slowly and with particular
caution on loading ramps, ensuring
that the wheels do not drive over
the edges of the loading ramps –
14.19)
danger of falling!
Do not change speed or direction
abruptly.
On public roads, the machine may
only be transported by means of a
suitable vehicle or trailer. Do not
tow!
● Before loading, select the highest
cutting level. (
14.9)
14.14)
14.13)
4.3)
12.6)
107