Removing And Installing The Battery; Charging The Battery; Lubrication - Stihl RT 4082 Gebrauchsanleitung

Attach the terminal connector of black
connection cable (2) to the battery
negative (–) terminal.
Tighten the connection cable with
screw (5), washer (6) and nut (7) using
two (A/F 8) spanners.
Tightening torque: 4 - 5 Nm
14.20 Removing and installing the
battery
Removing the battery:
● Remove the steering column cover.
( 14.16)
● Disconnect the battery. (
106
Release retaining clasp (1) and remove
battery (2).
● Insert the retaining clasp.
● Install the steering column cover.
( 14.17)
Installing the battery:
● Remove the steering column cover.
( 14.16)
14.19)
Insert battery (1) and insert retaining
clasp (2).
● Connect the battery. (
● Install the steering column cover.
( 14.17)

14.21 Charging the battery

Risk of injury!
In order to charge the battery using
another charging system, the
battery must be removed.
The specifications on the battery
supplementary sheet and on the
charger must be observed.
● Stop the engine. ( 12.3)
● Remove the ignition key and keep it in a
safe place.
● Remove the battery (
charge using a suitable charging
system.

14.22 Lubrication

Lubricate the two front steering knuckles
via the two grease nipples on the front axle
using commercially available grease.
Lubricating:
● Stop the engine. ( 12.3)
● Remove the ignition key and keep it in a
safe place.
● Engage the parking brake. (
● Unload the front axle by supporting
(lifting) it. ( 14.10)
● Clean the grease nipple.
0478 193 9904 A - EN
14.19)
14.20) and
8.10)