Safety Information For The Installer - Sentiotec K2 Next Montage- Und Gebrauchsanweisungen

Instructions for installation and use

2.2. Safety information for the installer

● Installation may only be performed by a qualified electrician or
similarly qualified person.
● Installation and connection of the sauna control unit may only be
performed when the power supply is disconnected.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
● The sauna control unit must be installed outside the sauna cabin
at a height of approx. 1.70 m, or in accordance with the rec-
ommendation given by the sauna manufacturer. The ambient
temperature must be within a range spanning -10 °C to +40 °C.
● The heater sensor must be attached in a way that ensures it is
not affected by an inflow of air.
● Observe all regulations applicable in the installation location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 6/26