Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance; Fuses; Technical Data - Truma Combi D4 CP plus ready Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für Combi D4 CP plus ready:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Maintenance

Only original Truma parts may be used for maintenance and
repair work.
The device must be descaled on a regular basis (at least twice
a year).
We recommend the Truma system care set for cleaning, dis-
infecting and maintenance of the boiler. Other products – in
particular products containing chlorine – are unsuitable.
The effectiveness of the use of chemicals to combat microor-
ganisms in the unit can be increased by heating the water in
the boiler to 70 °C at regular intervals.
– Set water temperature to 60 °C.
– Switch on device.
Once the water in the boiler has reached a temperature
of 60 °C, the burner will switch off. The unit must stay
switched on for at least 30 minutes and no warm water may
be removed. The residual heat in the heat exchanger will heat
the water up to 70 °C.

Fuses

The fuses are located in the electronic control unit, beneath
the connection cover. When replacing a fuse, be sure to use
the same type.
Device fuse:
10 A (slow-acting) (T 10 A)
Burner fuse:
20 A (slow-acting) 6.3 x 32 mm
Fig. 4
T 20 A
T 10 A

Technical data

Found by Truma Test conditions
Fuel
Diesel as per EN 590
Water contents
10 litres
Heating time from approx. 15 °C to approx. 60 °C
Boiler approx. 20 minutes (measured according to EN 15033)
Heater + boiler approx. 80 min.
Pump pressure
max. 2.8 bar
System pressure
max. 4.5 bar
Rated thermal output (automatic operating level)
2000 W / 4000 W
Fuel consumption
220 – 452 ml/h (110 ml/h in normal mode with average heat
output of 1000 W)
Air delivery volume (free-blowing without warm air duct)
max. 287 m³/h
Power consumption at 12 V
Heater + boiler 1.8 – 4 A (in control mode between "Off" and
"Lowest operating level" less than 1.8 A)
Heat up boiler without heating operation max. 1.8 A
Stand-by approx. 0.001 A
Heating element – FrostControl (optional): maximum 0.4 A
Weight (not containing water)
Heater unit:
Heater unit with peripheral devices:
Right reserved to make technical changes!
Dimensions
450 mm
Fig. 5
15.8 kg
17.2 kg
525 mm
13

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis