6 Commissioning, operation
6.12 Factory settings
The calibrator is delivered with five commonly-used factory settings. These settings are shown
below.
GB
Setting 1:
The upper display is set to [P1] mode and the middle is set to "mA"; the lower is off.
Setting 2:
The upper display is set to [P2] mode and the middle is set to "mA"; the lower is off.
Setting 3:
The upper display is set to [P1] mode and the middle is set to [P2]; the lower is off.
Setting 4:
The lower display is set to [P1] "SWITCH TEST" all other displays are off.
34
WIKA Operating Instruction, Model CPH65I0