Display Mode - Endress+Hauser Nivotester FTR525 Anleitung

Nivotester FTR525
7.4.3.3

Display mode

System Display
→
3000 3500
This function is used to select the display mode that defines how the measured values of the
maximum of two measuring channels are displayed.
Options: " % limit (1M)", "Bargraph limit (1M)", "Tag limit (1M)", "% motion (2M)" *,
"Bargraph motion (2M)" *, "Tag motion (2M)" *, "Bargraph alternating (1M/2M)" *,
"Tag alternating (1M/2M)" *
The selection options marked with a * are only available for the FTR525-**2.
% limit (1M)
1M
The percentage value of the level limit detection (measuring channel 1, 1M) is displayed.
Bargraph limit (1M)
1M
Grenzstand 1
The percentage value and associated bargraph (0 to 100 %) of the level limit detection (measur-
ing channel 1, 1M) are displayed. If one or two switching outputs are assigned to measuring
channel 1, the corresponding switch points are also displayed (switching output 1: Upper
switch points; switching output 2: Lower switch points).
1M
Grenzstand 1
Tag limit (1M)
1M
Tag number1
The Tag and the percentage value of the level limit detection (measuring channel 1, 1M)
are displayed.
Tag input → 68
Endress+Hauser
Display mode
→
3520
8 7
%
8 2
%
%
5 2
%
%
5 2
%
Commissioning
69