Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning
7
Commissioning
7.1
Function check
Make sure that the post-installation and post-connection check has been carried out before
you commission your measuring point:
• "Post-installation check" checklist → 50
• "Post-connection check" checklist → 53
After the supply voltage has been applied, the green LED lights up and the display jumps to
the measured value display after initialisation.
The first time the device is commissioned, you can program the setup in accordance with the
description of these Brief Operating Instructions available in the following sections.
For a more detailed description of the commissioning process: See the Operating
Instructions for the device.
7.2
Switching on the measuring device
The Nivotester FTR525 is powered up by connecting the supply voltage.
The local display automatically switches from the start-up display to the measured value
display after successfully starting up.
If nothing is shown on the local display or a diagnostic message is displayed:
See the Operating Instructions for the device.
7.3
Setting the operating language
The operating language is set in function 3510; English (factory setting) and German are
available for selection as standard.
Other operating languages as a replacement for German are available on request.
7.4
Configuring the measuring device
Configuration includes application-specific settings (such as basic calibration), assignment and
the behavior of the outputs (such as switch-on and switch-off points) as well as the behavior
of the display (such as the operating language and display mode).
The following sub-sections illustrate the corresponding configuration options.
• The numbers assigned to the functions and function groups are added in brackets for easier
navigation in the following sub-sections.
• Overview of all available functions and factory settings → 73
60
Nivotester FTR525
Endress+Hauser
Werbung
Kapitel
Inhaltsverzeichnis
