Dot Matrix Display - Endress+Hauser Nivotester FTR525 Anleitung

Operating options
6.3.4 Minimum/maximum value display
1M
Grenzstand 1
1M


The following applies for the display of the minimum/maximum value:
• A fter  is pressed, the measured value display switches to the display for the minimum
value, and pressing this button again will switch to the display for the maximum value
(in reverse order in the case of ).
• In the case of an alternating display between measuring channel 1 (1M) and measuring
channel 2 (2M), this display will alternate as well.
• The minimum/maximum values are determined and saved every 15 minutes, and the
previous values are overwritten.
6.3.4

Dot matrix display

In addition to the display options for the dot matrix display illustrated in the previous sections,
it can also be used for inputting the function parameters.
Example: Alphanumeric input of a Tag
3 1 1 1
Tag
The input is carried out by selecting one of the following characters with  or  at the flash-
ing position:
• Numbers 0-9
• Letters a-z, A-Z
• Special characters + - * / \ % °
In addition, the following symbols are used in editing mode:
• ← (skip left)
• � ← (skip left and delete character)
•  (Enter: Apply, end input at this point)
•  (Cancel editing mode)
The digits 0-9 and the decimal point are available for entering numbers.
58
8 2
%
%
6 5
1M
→ 
▾
μ . , ; : ! ? _ # $ " ' ( ) ~
2 3
Min
%
9 3
Max
%
3 1 1 1
 _ _ _ _ _ _ _ _ _ _ _ _ _ _
Nivotester FTR525
Endress+Hauser