Abicor Binzel ABIDRIVE 2 Betriebsanleitung Seite 66

10 Troubleshooting
Front panel display Error description
Left Right
e r r 10 • Motor current protection
Tor ch • Prevents welding from
Tab. 19 List of error messages on the display
EN - 30
Cause
• Welding current too high
• Wire feeder is blocked
• Torch set down incorrectly when
starting accidentally the ABIDRIVE is switched on
• Torch set down incorrectly when
the temperature protection is
switched off
TIG cold-wire feeder
Troubleshooting
• Clean all moving parts, roll
bearings and contact tips,
replacing them if necessary.
• Work can continue once the
warning signal has disappeared
(after approx. 20 seconds).
• It is not necessary to switch off
the ABIDRIVE.
• The warning disappears after
the trigger on the torch is
released.