Advanced Functions - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

6 Putting into operation

6.3.3 Advanced functions

Press buttons (1) and (2) simultaneously to switch to parameter selection mode.
1 Wire retraction/function button
Fig. 8 Advanced functions
Display indicators
Left display (1)
Indicator Description
F1 Soft start (during operation)
F2 Wire retraction feed rate
F3 Soft start for wire feed
F4 Wire feed rate
F5 Function types of the torch triggers
F6 Power source shut down with
2 and 4-cycle
F7 Special interval function
Tab. 10 Display indicators for advanced functions
Depending on the default settings, the knob (5) can be used to increase or decrease the values.
 Fig. 5 Front panel display on page EN-12
EN - 14
1
2
2 Wire feed
Right display (2)
Indicator Description
Value between Indicator (4) (bottom) in seconds
Off and 2.0 Wire slowly starts to run
 Fig. 5 Front panel display on page EN-12
Value between Indicator (3) (top) in m/min
0.5 and 3.0
 Fig. 5 Front panel display on page EN-12
ON – OFF Wire slowly starts to run
0.5 – 8.0 Indicator (3) (top) in m/min
 Fig. 5 Front panel display on page EN-12
A/b/C Only possible if the power source should also
be controlled
 6.11 Connecting the torch and the welding
device on page EN-25
2 – 4 Optional torch required
ON – OFF Wire retraction while welding
TIG cold-wire feeder