Connecting The Intermediate Cable Assembly En - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

6 Putting into operation
6.5 Connecting the intermediate cable assembly
NOTICE
• Only use intermediate cable assemblies and torch cable assemblies designed for the ABIDRIVE V2.
• For information on connecting the intermediate cable assembly to the power source, please see the
1
1
2
3
4
5
Fig. 14
1 Insert the power source control lead (5) into the ABIDRIVE connection bush (7) and secure it by turning
the nut clockwise.
2 Insert the power source control lead connector (2) into the power source connection bush (1) and secure
it by turning the nut clockwise.
3 Insert the power cable for the power source (9) into the ABIDRIVE welding current connection bush (7)
and secure it by turning the nut clockwise.
4 Insert the power cable for the power source (11) into the welding current connection bush for the power
source (1) and secure it by turning the nut clockwise.
5 Connect the ABIDRIVE gas connector (6) to the ABIDRIVE connection bush (7).
6 Connect the gas connector power source (3) to the power source connection bush (1).
7 Connect the coolant supply and return hoses (8) and (10) to the ABIDRIVE connectors (7).
8 Connect the coolant supply and return hoses (12) and (13) to the power source connectors (1).
EN - 20
operating instructions for the relevant power source.
2
13 12
Power source
Power source control lead connector
Power source gas connector
Intermediate cable assembly
ABIDRIVE control lead connector
Connecting the intermediate cable assembly
3 4 5
11 10
6 ABIDRIVE gas connector
7 ABIDRIVE V2
8 Coolant return (red)
9 ABIDRIVE welding current
TIG cold-wire feeder
6 7
9 8
10 Coolant supply (blue)
11 Welding current power source
12 Coolant return (red)
13 Coolant supply (blue)