Putting Into Operation; Putting Out Of Operation - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

TIG cold-wire feeder
Symbol

7.3 Putting into operation

Personal injury and property damage from electrostatic charge
During the ignition process and when welding, the surroundings and individuals may become
electrostatically charged. When earthed objects or devices are touched, this built-up voltage is
discharged. Electrostatic discharge occurs.
• Do not touch any metal parts in or on the device during the ignition phase.
• Connect the ABIDRIVE only to properly earthed power sockets.
• Operate the ABIDRIVE only with an intact connection lead with a protective conductor and safety
• Only place the welding torch on insulated materials when it is in use.
 Fig. 20 Overview of connections and control elements on page EN-26
1 Switch on the main switch (1).
2 Open the valve on the shielding gas cylinder.

8 Putting out of operation

NOTICE
• When putting the system out of operation, ensure that the procedures for switching off each of the
 Fig. 20 Overview of connections and control elements on page EN-26
1 Switch off the main switch (1).
2 Close the valve on the shielding gas cylinder.
Description
Coolant supply (12)
Gas inlet (13)
DANGER
plug.
welding system components are observed.
8 Putting out of operation
EN - 27