Positioning Guide Arms; Connecting The Weld Start Signal Cable - Abicor Binzel ABICAR ADVANCED Betriebsanleitung

6 Putting into operation

6.3 Positioning guide arms

Fig. 7
A Component
B Guide arm, rear
C Knurled screws
In order to ensure restricted guidance along the contact surface, the guide arm (E) must be adjusted so that
it is shorter than the guide arm (B). The adjustment depends on the direction of movement and the length of
the guide arm. The difference should be approx. 10 mm for a straight component.
Loosen the knurled screw (C) and advance by 10 mm or one groove.
1
Retighten the knurled screw (C).
2

6.4 Connecting the weld start signal cable

Electric shock caused by incorrectly installed and damaged cables
Use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed or worn parts replaced only by a qualified electrician.
Risk of injury due to fire
A fire may occur due to improper use or connection. They could cause major burns.
► Ensure that the operating voltage specified on the nameplate corresponds to the connection voltage.
The device can be operated with two welding torches.
EN - 14
Adjustment of restricted guidance
A
G
Travel direction
C
WARNING
WARNING
ABICAR ADVANCED
D Angle of approach
E Guide arm, front
Contact surface of the component
B
C
D