User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch FSA 500 Originalbetriebsanleitung

2.

User information

2.1

Important notes

Important information on copyright, liability and
warranty provisions, as well as on equipment users
and company obligations, can be found in the separate
manual "Important notes on and safety instructions
for Bosch Test Equipment". These instructions must
be carefully studied prior to start-up, connection and
operation of the FSA 500 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found
in the separate manual "Important notes on and
safety instructions for Bosch Test Equipment". These
instructions must be carefully studied prior to start-
up, connection and operation of the FSA 500 and must
always be heeded.
2.�

Electromagnetic compatibility (EMC)

The FSA 500 satisfies the requirements of the EMC
directive 2004/108/EG.
i
The FSA 500 is a class/category A product as de-
fined by EN 55 022. The FSA 500 may cause high-fre-
quency household interference (radio interference)
so that interference suppression may be necessary.
In such cases the user may be required to take the
appropriate action.
2.4 Measurement category as per
EN 61�1�-1
EN 61010-1 specifies the general safety requirements
for electrical testers and measuring instruments and
defines the measurement categories from I to IV.
The FSA 500 is intended for use in measurement
category I (CAT 1), i.e. for measurements in circuits
with no direct connection to the mains.
2.�

Bluetooth limitations

There are limitations in the following countries
(e. g. Bluetooth modules may only be used in enclosed
rooms) when operating Bluetooth Class 1 modules:
Egypt, France, Jordan, Pakistan, Peru, Saudi-Arabia,
Sri Lanka, Thailand and Turkey.
In the following countries, no Bluetooth modules
are to be used (Status: March 2006):
Algeria, Ethiopia, Bolivia, Burma, Georgia, Guatemala,
Cambodia, Qatar, North Korea, Senegal, South Africa,
Syria, United Arab Emirates, West Sahara.
The FSA 500 is a class 2 device as per R&TTE directive
1999/55/EC (refer to the "Bluetooth restrictions"
Section).
Robert Bosch GmbH
2.6
Bluetooth is a wireless connection in the unlicensed
2.4 Ghz-ISM-Band (ISM: Industrial, Scientific, Medical).
This frequency range is not subject to any governmental
laws and may be used in most countries without a
license (Exceptions are found in chap. 2.5). This results
in many applications and devices transmitting on this
frequency band however. This can cause frequency
interference between these devices.
Depending on the environmental conditions,
disturbance can occur in the Bluetooth connection,
e. g. in WLAN connections (WLAN: Wireless Local
Area Network), wireless telephones, radio-controlled
thermometers, radio-controlled garage door openers,
radio-controlled light switches or radio-controlled alarm
FSA 500 and must and must systems.
i
i
Pay attention to the following to ensure the best
possible connection:
1. The Bluetooth radio signal always tries to find the
2. If the PC is standing on a Bosch trolley, the Blue-
3. In the event of problems with the Bluetooth link, the
4. It is not possible to operate any other item of
User information | FSA ��� | 21
Important information regarding
Bluetooth
Bluetooth can lead to interference in the band-
width of the WLAN-network. The antennas of Blue-
tooth and WLAN devices should be positioned at least
30 centimeters apart. Bluetooth-USB adapters and
WLAN must not be placed in adjacent USB sockets in
the PC/Laptop. A USB extension cable (special acces-
sories) should be used to ensure that the Bluetooth-
USB adapter is separate from the WLAN stick.
Generally, people who wear a pacemaker or other
essential electronic device should exercise extreme
caution when using wireless technology, as it may
impair the function of their particular device.
most direct path. When setting up the PC/Laptop
with Bluetooth USB adapter make sure there are
as few obstacles as possible (e. g. steel doors and
concrete walls) which could interfere with the radio
signal from and to the FSA 500.
tooth USB adapter should be connected by way of
a USB extension cable from outside the trolley. Use
is to be made for this purpose of the USB extension
cable (special accessory) 1 684 465 564 (1.8 m).
USB link can be activated and used instead of the
Bluetooth connection.
Bluetooth hardware fitted or plugged into the PC/
Laptop, as this would interfere with data communi-
cation between the FSA 500 and the PC/Laptop.
en
|
1 689 989 115 2011-09-20