Copy And Paste Functions - CAKEWALK Z3TA+ 2.1 Bedienungsanleitung

Command
Reverse
Remove MIDI Control
Change MIDI Config
Table 37. MIDI Learn options (Continued)
Any MIDI controller can be learned except CC0, CC32 (bank change), CC120 (all sounds off),
CC121 (all controllers off), and CC123 (all notes off).
Aftertouch and pitch bend MIDI messages can also be assigned as standard controllers. When
Pitchbend is assigned, the center will be calculated according to the min and max settings for
selected parameter.
In the Options menu (in the Master section), the Show MIDI Config File option displays all
currently selected MIDI-learn settings as a text file.
Z3TA+ allows you to store multiple MIDI configurations. To switch between configurations, right-click
a control and choose Change MIDI Config on the pop-up menu.

Copy and Paste functions

You can copy and paste settings for shapers, oscillators, filters, LFOs, EGs and delays.
To copy/paste settings for oscillators, filters, LFOs, EGs, or delays, right-click on its page selection
button and choose Copy. Then right-click on the destination component and choose Paste.
To copy/paste shaper settings to a different oscillator, right-click on the waveform in the Shaper
window, choose Copy, select the destination oscillator, and choose Paste.
Copy and Paste functions
Description
Inverts the parameter polarity.
Remove an assigned MIDI control.
Choose one of ten available MIDI configurations.
65