Midi Learn; Control Type - CAKEWALK Z3TA+ 2.1 Bedienungsanleitung

MIDI Learn

Z3TA+ features one of the most advanced MIDI control customization systems on virtual
synthesizers. It allows you to assign any controller on the screen to any MIDI controller, even
assigning multiple controllers to a single parameter or vice-versa.
The operation of MIDI-learning a controller is performed as follows:

Control type

MIDI Learn procedure
Sliders Right-click.
Selectors Hold down the SHIFT key and right-click.
Range Hold down the SHIFT key and right-click.
X-Y Pad Hold down the SHIFT key and right-click the pad.
Table 36. How to enable MIDI Learn
Once you select MIDI Learn, Z3TA+ enters a “"waiting”" mode, expecting a MIDI controller to be
received. You can send the controller by using a physical MIDI control device or by using your
sequencer to send a MIDI continuous controller (CC). Multiple controls can be set to “"waiting”" mode
at once.
Note: When sequencers Start/Stop/Start Audio Streaming functions occur, they send numerous
controllers. Avoid those operations while Z3TA+ is in “"waiting”" mode, as it might learn
unexpected controller numbers. Also, arpeggiator patterns may contain controller data,
particularly pitch wheel, which will similarly be MIDI Learned to controls.
As soon as a MIDI controller arrives, Z3TA+ assigns it to the selected controls. The controls will
display the new value according to the incoming controller value.
Once a control is assigned, you can scale it (setting the minimum and maximum) and reverse the
control polarity. To perform this operation, call the MIDI Learn menu again. New options will appear:
Command
Add MIDI Control
MIDI Forget
Set Min
Set Max
Table 37. MIDI Learn options
64
MIDI Learn
Description
As it is possible to assign multiple controllers to any parameter, this option will
always remain active.
Removes the MIDI controller association from this parameter.
Sets the minimum value this parameter will have, when the incoming MIDI control
value is zero.
Sets the minimum value this parameter will have, when the incoming MIDI control
value is 127.