CAKEWALK Z3TA+ 2.1 Bedienungsanleitung Seite 34

LFO modes
Mode
TIME MORPH
ADD
IADD
SUB
ISUB
MUL
MIN
MAX
HALF1
HALF2
ONE-SHOT
Table 15. LFO modes
Combining Waveforms 1 and 2 with all the LFO modes, you can get some extremely complex
effects. Additionally, the LFO speed can be modulated with any modulation source.
34
The Synthesizer
Description
The output of the LFO will morph between Wave 1 and Wave 2 in the time set by Time
slider.
The output of the LFO will be the mix of Waveform1 and Waveform2. The mix balance
is controlled with the Time slider. (The output won’'t change over time.)
Same as ADD, but Waveform1 is inverted.
Same as ADD, but Waveform2 is inverted.
Same as ADD, but both Waveforms 1 and 2 are inverted.
Output of LFO is the sample-per-sample product of Waveform1 and Waveform2
Output of the LFO is the minimum value between Waveform1 and 2:
LFO = min (wave1, wave2).
Output of the LFO is the maximum value between Waveform1 and 2:
LFO = max (wave1, wave2)
The output of the LFO is the first half-cycle of Waveform1 and second half-cycle of
Waveform2.
The output of the LFO is the first half-cycle of Waveform2, and second half-cycle of
Waveform1.
The LFO will output only one cycle, then it will stop.