CAKEWALK Z3TA+ 2.1 Bedienungsanleitung Seite 36

Amplifier (Amp) and general-purpose EG (1-6) parameters
Parameter Description
Attack Shape Attack stage output will follow the curve selected by this control (linear, exponential or
power).
Decay Shape The output variation during decay stage will follow the curve selected by this control
(linear, exponential, or power).
Sustain Shape The output variation during sustain stage will follow the curve selected by this control
(linear, exponential, or power).
Release Shape The output variation during release stage will follow the curve selected by this control
(linear, exponential or power).
Delay 0 to 10s.
The time from Note-On event till start of the EG.
Attack 0 to 10s.
After the delay stage, the EG starts rising from EG = 0 to EG = 1. It reaches 1 in the time
set by this control, and following the curve set by Attack Shape.
Decay Time 0.01s to 10s.
After the attack stage, the EG reached EG = 1. Then it enters the slope stage, which leads
to EG = Decay Time, set by this control.
Decay Level 0.10% to 99%.
This control adjusts the time it takes the EG to perform the slope stage (moving from EG =
1 to EG = Decay Time, following the curve set by Slope Shape).
Sustain Time 0.01s to 10s.
After the slope stage, the output will move from Decay Time to Sustain Level, performing
the decay stage, in the time set by this control.
Sustain Level 0 to 1 (0 to 100%).
After the decay stage, the output of the EG will remain at this value till a Note-Off event is
received for this note.
Release 0.01s to 10s.
When the Note-Off event is received for this note, the EG output will return to zero. This
control sets the time it takes to reach zero value.
Amount -1 to +1 (-100% to +100%, with zero at center).
The output level of the EG, in normal or reverse operation.
When this control is set to zero (default value, obtained by double-clicking the control) all
CPU usage for the EG is recovered.
Table 16. Amplifier (A) and general-purpose EG (1-6) parameters
36
The Synthesizer