CAKEWALK Z3TA+ 2.1 Bedienungsanleitung Seite 15

Range controls
Figure 6. Range control
The Range parameter in the matrix also uses a specially designed control that allows you to set two
parameters in the same control: Min and Max, by using left and right click and drag operations.
Range controls also keep the focus, and allow for keyboard and mouse wheel adjustments in
different sized steps:
Key
Left/Right arrows
Up/Down arrows
Windows: Page Up/Down
OSX: [fn] Function Key + Up/Down arrows
Windows: Wheel
OSX: Wheel or Trackpad
Windows: SHIFT+Wheel
OSX: SHIFT+Wheel or Trackpad
Table 5. Matrix Range parameter
When you operate the Range controls in the Shaper, the mouse pointer disappears and the
selectivity of the operation is expanded to ensure smooth waveshaping transitions.
On the Effects page, the Drive and Compressor sections use a similar Range control, but their Min
parameter is disabled.
You can assign any MIDI controller to any Range control. To do so, hold down the SHIFT key and
right-click the Range control. The controls will move according to incoming MIDI messages and
scaling when “"learned.”" For more information about this, see “"MIDI Learn”" on page 64.
Using the controls
Description
±1% of the control
±5% of the control
±20% of the control
±5% of the control
±1% of the control
15