CAKEWALK Z3TA+ 2.1 Bedienungsanleitung Seite 37

Pitch EG parameters
Parameter Description
Delay 0 to 10s.
The time from Note-On event till the start of the EG.
Start -100% to +100%.
The initial value for the EG after the delay stage.
Attack Time 0 to 10s.
After delay stage, the EG will start the attack stage, where it will go from EG = Start
Level to EG = Attack Level. This control adjusts the time to perform the attack stage.
Attack Level -100% to +100%.
The level the EG reaches after the attack stage.
Decay 0.01s to 10s.
After the attack stage, the EG will enter the decay stage, after which it will reach EG =
zero, and will remain in this status while the note is on.
This control adjusts the time to perform the decay stage.
Release Time 0.01s to 10s.
After note is released, the EG will enter the release stage, after which it will reach EG
= Release Level.
This control sets the time for the release stage.
Release Level -100% to +100%.
The final level for the EG after a Note-Off event is received for this note.
Amount -100% to +100%.
The output level of the EG, in normal or reverse operation.
When this control is set to zero (default value, obtained by double-clicking the control)
all CPU usage for the EG is recovered.
Table 17. Pitch EG parameters
As mentioned above, you can assign any slider or curve selector to any MIDI controller by right-
clicking on them (for curve selectors, hold down the SHIFT key and right-click). If the parameter
range is scaled (using min or max), the range of the scale will be shown with a indicator in the slider
background. For more information about assigning MIDI to a slider, see “"MIDI Learn”" on page 64.
The Synthesizer
37