CAKEWALK Z3TA+ 2.1 Bedienungsanleitung Seite 33

LFO parameters
Parameter Description
Wave 1 The main waveform for the LFO.
Waveforms 1 and 2 are combined according to the “"LFO Mode”" setting.
Wave 2 The secondary waveform for the LFO.
Waveforms 1 and 2 are combined according to the LFO Mode setting.
Mode LFO Mode.
See “"LFO modes”" on page 34.
Tempo Sync The beat division when synchronizing to host tempo.
A indication of “"1”" means one beat, so if the host tempo is set to 120 bpm the LFO will
produce 120 cycles in this setting.
Phase The starting phase for the LFO on Note-On, in 45-degree steps.
When you select “"Free,”" the LFO won’'t restart its phase on Note-On events.
Offset -100% to +100%
Value offset for the LFO output.
Delay 0 to 10s.
The delay before the LFO starts its operation after a Note-On event is received.
Fade In 0 to 10s.
The fade-in time for the LFO. The LFO output will gradually rise from zero to reach its
maximum after Fade time.
Morph / Time (in 0 to 20s.
Time Morph mode) The time for the Morph operation. This slider has some other uses, according to the LFO
mode. Check the “"LFO Modes”" table for more information.
Speed 0.01Hz to 20Hz.
The LFO speed.
Amount Reduces the range of the LFO from 100% to 0%.
Table 14. LFO parameters
The Synthesizer
33