Filter Parameters - CAKEWALK Z3TA+ 2.1 Bedienungsanleitung

Filter parameters

Parameter Description
Link Links the parameters of both filters together, except in the case of the pan, which links
them to move opposite each other.
Parallel / Dual Normally each filter lives on a bus, and after the filters the buses are routed together. In
Dual Mode, the buses are routed together before the filters, and then the 2 filters are
routed 1 after the other.
Filter Type Selects the filter type:
•• OFF
•• 12dB/oct LPF, 24dB/OCT LPF, 36dB/OCT LPF
•• 12dB/oct HPF, 24dB/OCT HPF,
•• 12dB/oct BPF, 24dB/OCT BPF,
•• 12dB/oct BRF, 24dB/OCT BRF,
•• FORMANT
•• RESO 2 BPF
•• RESO 2 BRF
•• RESO 3 BOOST
•• COMB
Filter Limiter Changes the filter limiter response time between Off, Slow, and Fast.
Reso boost By switching the Reso Boost parameter between on and off, it changes the resonance
scaling factor to accommodate higher or normal resonance modes.
Separation Adjusts the frequency distance between each resonance peak of the filter, where
applicable.
Cutoff The filter cutoff point.
Resonance The filter resonance.
Pan Defines the stereo position of the filter output, from full L to full R.
Level Filter output level.
Table 12. Filter parameters
The Synthesizer
31