Warranty Conditions - Rothenberger ROFUSE II Bedienungsanleitung

ERROR 12
ERROR 13
ERROR 14
ERROR 22

17. Warranty conditions

The material is guaranteed against manufacturing defects, the material used and elaboration within our remit.
The warranty is void when:
• 12 months have elapsed since the supply of the material;
• the material has been modified or handled;
• the material has been used in working conditions other than those stipulated by the supplier.
Our warranty is limited to the replacement of faulty parts or their repair by our Technical Support Service, whilst it
fully excludes compensation or the recognition of damage of any kind caused by using the products sold.
As a result of the continuous improvements made to the product there may be discrepancies between this manual and the actual product. Any
improvement made does not require informing customers in advance.
Nevertheless, the technical features of the product remain under warranty.
35 35 35
WARRANTY CONDITIONS
The internal temperature of the equipment is too high.
The machine's internal temperature sensor has registered excessive temperature in the
circuits. The causes could be excessively frequent welding operations using bushings with
large diameters or exposure to atmospheres with high temperatures. Wait for 30 minutes
to enable the equipment to cool.
Possible problems in the temperature sensors.
Primary power supply stopped during the cycle.
The power supply voltage has stopped during the welding cycle.
Check the available power. At least 5 kVA required (when using bushings with a large
diameter as well).
Memory empty.
There is no information in the memory.
Manual stop of the equipment during the cycle.
Cycle stop with the "RESET" button.
ENGLISH