Rothenberger ROFUSE II Bedienungsanleitung Seite 30

USE OF THE EQUIPMENT
WELDING
SCRAPE/CLEANING
YES=VALID
COUPL./POSIT.
YES=VALID
T°/C° correction
YES=VALID
V:8.0 T:1000
YES=VALID
Tc:0123 Tn:0123
N 10 V 8.0 °C23
CYCLE OK
COOLING
MIN : XX
END DISCONNECT
SLEEVE "VALID"
REPEAT =VALID
OTHER=RESET
The preliminary operations are essential for achieving perfect welding. Perform
these operations and then confirm them with "VALID".
Confirm the correct positioning of the welding pipes in the relevant aligning tool
with "+" or "-" buttons and confirm by pressing "VALID". In the event of not
being able to use the aligning tool press the "+" or "-" buttons whilst always
confirming the selection made using the "VALID" button.
This function only appears in the MANUAL operating mode. Select This function only appears in the MANUAL operating mode.
whether you wish the equipment to automatically correct the time in relation to
the outside temperature. If the correct time according to the information featured
on the joint is already set, select "NO" and press "VALID" to confirm.
Carefully check the selected parameters. If correct proceed with the "VALID"
button; otherwise correct them with the "RESET" button.
During the welding the following messages are shown on the display:
• Welding voltage
• Welding time in relation to the outdoor temperature
• Target welding time required at 23°C
• Welding number
• Ambient temperature
In the event of an emergency stop press "RESET". Press "VALID" to repeat the
selected cycle and "RESET" once again to modify the selection.
Warning: Before repeating the welding wait until the bushing has
completely cooled.
Once the welding cycle has been completed correctly a message is displayed along
with an acoustic signal.
Otherwise, an intermittent acoustic signal is heard and the "ERROR" message
along with a reference number is shown to indicate the error in question. See
ERROR MESSAGES.
To perform more welding operations with the same parameters as the previous
one press "VALID"; otherwise press "RESET".
ENGLISH 30 30 30