Use Of The Equipment - Rothenberger Rofuse Ii Bedienungsanleitung

WELDING
SERIAL NUMBER
XXXXXXXXXX
TIME
10:30 11/12/2007
OPERATOR
XXXXXXXXXX
SITE
XXXXXXXXXX
ACCESS. BRAND
XXXXXXXXXX
BAR CODE (*)
READ BAR CODE
XXX
TYPE: XXX
D. XX V: XX.X
T: XXXX
ACCESS. BRAND
XXXXXXXXXXX
TYPE:I D:20
V:8.0
29 29 29

USE OF THE EQUIPMENT

Timed message of more or less 3".
Serial number XXXXXXXXX
Timed message of more or less 3".
DATE
Date and time.
Timed message of more or less 3".
In order to enter the operator code use the "+" and "-" buttons by
selecting the desired characters and confirming them with "VALID".
These are available in a sequence of symbols, numbers from 0 to 9 and letters.
Timed message of more or less 3".
In order to enter the "Site" code use the "+" and "-" buttons by selecting
the desired characters and confirming them with "VALID".
These are available in a sequence of symbols, numbers from 0 to 9 and letters.
Select operating mode: here it is possible to use the equipment
with the scanner or in manual mode.
Barcode: the welding data are automatically set using the magnetic
cards or the barcodes placed in the sleeves by the manufacturer
(see SAFETY).
Manual: the welding data are manually set by the operator.
Read the barcode on the bushings.
The following comments will be the same for manual welding.
At the end of the cycle it is possible to repeat the welding cycle (by
reading the barcode again) or to return to the OPERATOR position.
Timed message of approximately 3". In order to enter the accessory
brand use the "+" and "-" buttons by selecting the desired characters
and confirming them with "VALID".
These are available in a sequence of symbols, numbers from 0 to 9
and letters.
Select the accessory type (see table 1) and the diameter (D) by using
the buttons "+" and "-" followed by confirm with "VALID". Always
select the voltage (V) and the welding time (T) with "+" and "-" and
confirm each time with "VALID".
T:0000
CAUTION: The manufacturer must indicate the time and voltage values
in each accessory. Do not select values other than those indicated.
ENGLISH
MANUAL