Operation; Automatic Operation; Alarm Statuses; System Tank Too Full Alarm - Kessel Aqualift F Basic Anleitung Für Einbau, Betrieb Und Wartung

4

Operation

The backwater preventer must be functional during operation, see <25> in Fig. [5], page 38
4.1

Automatic operation

The lifting station is in automatic mode if no fault has been detected
and the green operating LED <1> comes on The wastewater pump is
switched on an off according to the wastewater level.
4.2

Alarm statuses

4.2.1 System tank too full alarm

If the level in the system tank exceeds the alarm level (float switch)
an alarm is triggered, the alarm LED <2> flashes and an acoustic
signal is heard. The wastewater pump is running.
This alarm status cannot be acknowledged, it is only switched off after successful pumping off.
The acoustic tone can be deactivated (press the alarm button briefly).

4.2.2 Power supply failure alarm

If the power supply fails, the green operating LED <1> goes out after one second, the alarm LED <2> flashes
and a repeated acoustic signal is heard. The wastewater pump can no longer be switched on.
* Temporary interruptions in the power supply do not trigger the alarm.
When the power supply is restored the control unit no longer shows this alarm status, the lifting station again
works in the automatic mode.
See chapter 4.3 for further alarm statuses
Operation
48 / 180
2 3 4
1
PUMP
Aqualift Basic Mono
5 6 7 8
Ill. [16]
2017/11