Function Description; Control Unit Operation - Kessel Aqualift F Anleitung Für Einbau, Bedienung Und Wartung

6.5 Function description (models Jan. 2010 or newer)
The lifting station is operating properly when the POWER
LED is on and there are no ALARM warnings being display-
ed. As wastewater enters the system the level will rise and
the PUMP 1 ON level will be activated by the float switch
which will activate one of the two pumps. The activation of

6.6 Control unit operation

Aqualift F Mono 400V
Kurzbedienungsanleitung:
ΠNetzverbindung herstellen
grüne Netzanzeige
g
g
Automatikbetrieb
 Niveau-Anzeige leuchtet
g Pumpniveau erreicht
Pumpen-Anzeige leuchtet
g Pumpe läuft
Ž Unterdrücken des
akustischen
Alarms mit
 Ausschalten/Handbetätigen
der Pumpe mit
Aqualift F Duo 400V
Kurzbedienungsanleitung:
Œ
Netzverbindung herstellen
g grüne Netzanzeige
g
Automatikbetrieb

Pumpe I-Anzeige leuchtet
g Pumpe I läuft
Pumpe II-Anzeige leuchtet
g Pumpe II läuft
Ž
Unterdrücken des
akustischen
Alarms mit

Ausschalten/Handbetätigen
der Pumpe mit
6. Commissioning / 7. Maintenance
NIVEAU
LEVEL
- Taste
PUMPE
PUMP
- Taste
Pumpe I
Pump I
- Taste
Pumpe II
- Taste
Pump II
the pump will lower the wastewater level until the PUMP OFF
level is reached – after the post run delay time has elapsed
the pump will turn off.
If the running time of the pump exceeds the pre-programmed
maximum running time of the pump, the pump will be turned
off and a warning LED will light. This occurrence can be ack-
nowledged by pressing the ALARM button on the control unit
– only after this button is pressed will the pump begin ope-
rating again. By pressing the pump button on the control unit
twice, the pump can be manually tested.
Control unit digital display
Operational status LED
Alarm status LED (pressing the ALARM but-
ton can acknowledge a warning)
Pressing the manual pump button twice will
activate the pump
LEVEL LED light – lights up when the PUMP
ON level has been reached (pump starts after
the pump start delay time has elapsed)
64