Scope Of Delivery; Setting Up And Connecting The Variobike 550/550C; Transport And Relocation - ergoline variobike 550 Gebrauchsanweisung

variobike 550/550C

2.2 Scope of Delivery

The standard scope of delivery consists of :
Order No.
100.550
or
100.558
413.093
475.087
optional:
300.937
200.540
424.160
200.177
200.177.L
313.422
424.016

2.3 Setting up and Connecting the variobike 550/550C

On request, our service personnel will install the variobike for you.
• Loosen screws and clamp lever for clamp fixture, and remove upper clamp jaw.
Insert handlebar, secure, and screw tight with screws and tighten lightly with clamp lever.
Adjust appropriate handlebar position and then tighten position with clamp lever.
• Connect cable at the top of the steering column with the control panel.
Position control panel on support, and fix with crews.
• Connect the unit's power plug via the supplied mains cable to power outlet with same voltage as
indicated at the indication label.
• If applicable, connect the ECG device to the RS232 interface.

2.4 Transport and Relocation

Once set up, you can easily move the variobike 550/550C to another location. Switch off the ergometer
and remove from the power supply !
Standing in front of the ergometer, grab the handlebars and tilt the variobike 550/550C towards you.
When the variobike is balanced on its front rollers, you can push it to the new desired location.
Caution when lowering !
Hard impact can damage the measurement electronics of the system !
variobike 550/550C Operation Manual
Art-No: 475.087
Operation Manual
Putting into Operation
Description
Ergometer variobike 550
Ergometer variobike 550C
Mains power cable
Operation Manual (German/English/French)
Adjustable cranks, complete with left + right pedal
Chip card PC-Software with reader for variobike 550C
Chip card ergoline (for variobike 550C)
Connecting cable, variobike 500 / 550 to PC (length 5 m)
Connecting cable, variobike 500 / 550 to PC (length 10 m)
POLAR receiver for variobike 550
POLAR chest-belt
E - 10
Version: 05/02