Maintenance And Cleaning; Troubleshooting; Disposal - Parkside PDMFG 180 A1 Originalbetriebsanleitung

Maintenance and cleaning

WARNING! RISK OF INJURY! Discon-
nect the tool from the compressed air
supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may have accumulated on
the tool (due to working processes). Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis. If dust is
produced or swirled up during maintenance,
it can be inhaled.
NOTE
To ensure correct functioning and a long service
life for the tool, pay attention to the following
points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning.
■ Check the speed and vibration levels after each
use.
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measure-
ment without any clamped tools. At a residual
pressure of 6.3 bar, the idle speed may not be
exceeded under any circumstances.
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and repaired.
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk. In doubt, contact the
Service Centre.
■ Clean the tool with a soft, dry cloth only.
■ Never use sharp or abrasive cleaning agents
under any circumstances.
PDMFG 180 A1

Troubleshooting

Fault Possible
cause
Speed too Motor parts
slow, air jamming due
escapes from to dirt.
the outlet.
Pressure sup-
ply too low.
Tool does Motor is
not move; jammed due
compressed to material
air escapes build-up.
completely
through the
outlet.

Disposal

The packaging consists of environmentally
friendly material. It can be disposed of in
the local recycling containers.
Do not dispose of the tool in the household
waste!
Your local community or municipal authorities can
provide information on how to dispose of the tool.
Remedy
Check the
pressure
supply filter
for contamina-
tion.
Check the
pressure
supply filter
for contamina-
tion.
Lubricate the
tool as de-
scribed in the
instructions.
If necessary,
repeat the
steps outlined
above.
Lubricate the
tool as de-
scribed in the
instructions.
GB │ IE │ NI │
15 ■