Additional Safety Notices; Before Use; Fitting The Connector Nipple; Lubrication - Parkside PDMFG 180 A1 Originalbetriebsanleitung

Additional safety notices

■ If applicable, observe special work safety or
accident prevention regulations for the handling
of compressors and compressed air tools.
■ Ensure that the maximum permissible working
pressure specified in the Technical Data is not
exceeded.
■ Do not overload this tool – use this tool only
within the capacity range specified in the
Technical Data.
■ Use safe lubricants. Ensure sufficient ventila-
tion at the place of work. In case of increased
discharge:
check the compressed air tool and have it
repaired if necessary.
■ Do not use this tool if you are distracted. Be
alert, watch what you are doing and use com-
mon sense when operating a compressed air
tool. Do not use tools when you feel tired or are
under influence of drugs, alcohol, or medica-
tion. A moment of inattention when operating
the tool can result in serious personal injuries.
■ Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
■ Keep compressed air tools out of reach of
children.
■ Do not store outdoors or in damp environments
without protection.
■ Protect the compressed air tool, in particular the
compressed air connection and operating ele-
ments against dust and dirt.
│ GB │ IE │ NI
■ 12

Before use

NOTE
► The compressed air tool may only be oper-
ated using cleaned, oil-atomised compressed
air and the maximum operating pressure of
6.3 bar must not be exceeded on the ap-
pliance. The compressor must be fitted with
a pressure reducer to regulate the working
pressure.
► Wind the supplied Teflon tape
threaded connectors.

Fitting the connector nipple

♦ Wrap the threads on the connector nipple
with the supplied Teflon tape
♦ Screw the connector nipple
inlet .

Lubrication

NOTE
► Regular lubrication is particularly important
to avoid friction and corrosion damage.
We recommend using a suitable special oil
for compressed air tools (e.g. Liqui Moly
compressor oil).
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously
and optimally lubricates the grinder as
a preparation stage after the pressure
reducer. A mist oiler releases fine drops
of oil into the air flow and it thereby
guarantees a regular lubrication.
–
Manual lubrication
If you do not have a mist oiler, lubricate
the tool before every use or longer work
sessions. Add 3–4 drops of pneumatic
oil into the connector nipple
around all
.
into the air
.
PDMFG 180 A1