Hazards Caused By Flying Parts - Parkside PDMFG 180 A1 Originalbetriebsanleitung

■ Keep work area clean and well lit. Cluttered or
dark areas invite accidents. This enables better
control of the tool in unexpected situations.
WARNING!
► Have your power tool serviced by qualified
trained personnel using only original spare
parts. This ensures that the safety of the tool
is maintained.
■ Keep children and other persons away from the
tool during operation. Distractions can cause
you to lose control.
■ Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewel-
lery or long hair can be caught in moving parts.
■ Put the trigger and the tool away in the case of
an unexpected stoppage of the compressor.
■ Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed air tools.
■ NOTICE! An undersized compressed air system
will reduce the efficiency of your tool.
■ Please ensure that you have read and under-
stood the safety instructions regarding multiple
hazards before installation, operation, repair,
service and replacement of any accessories
and before work near the automatic screw-
driver. Otherwise, there is a risk of serious physi-
cal injuries.
■ The automatic screwdriver should only be fitted,
adjusted or used by qualified and trained
operators.
PDMFG 180 A1
■ The automatic screwdriver may not be modified.
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator.
■ Do not lose the safety instructions – hand them
to the operator.
■ Never use a damaged automatic screwdriver.
■ The machines must be serviced regularly to
check whether the rated values and markings
required in the present part of ISO 11148 are
appended legibly on the machine. The em-
ployee/operator must contact the manufacturer
to obtain replacement stickers for labelling if this
is necessary.
Hazards caused by flying parts
■ If a workpiece or one of the accessory parts or
even the machine tool itself breaks, parts can
be thrown off at high speeds.
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance work.
The level of the required protection must be
evaluated separately for each individual task.
■ You must ensure that the workpiece has been
securely fixed in place.
■ Check regularly that the rotation speed of
the compressed air tool is not higher than the
specified rotation speed appended on the
compressed air tool. These rotation speed tests
must be conducted without any accessory tools
attached.
■ Ensure that sparks and fragments created
during work do not present any hazards.
■ Separate the compressed air tool from the
compressed air supply before replacing the
attachment or accessories or before you adjust
the settings, service or clean the tool.
GB │ IE │ NI │
7 ■