Switching On The Transmitter; C) Operation Of The Ir Transmitter - Reely SKY Thunder Bedienungsanleitung

b) Switching on the Transmitter
First push the control lever for the pitch function to the
bottom position (also see figure 1, item 10).
Push the function switch (see figure 1, item 7) from the
bottom position "OFF" to the top position "ON".
The LED of the operation control display (2) lights up
and shows that the transmitter is sufficiently supplied
with voltage.
If the LED of the operating control display is not lit but
flashes, you did not push the control lever for the pitch
function into the bottom position correctly.
Attention!
If the LED of the operating control display is only lit weakly or the charge process of the flight battery via the
transmitter takes disproportionally long, the inserted batteries must be replaced with fresh ones.

c) Operation of the IR Transmitter

Hold the IR transmitter in both hands and operate the two control levers (see figure 1, item 4 and 10) with your thumbs.
It is important that your IR transmitter diodes (see figure 1, item 1) are always "targeted" at the model to achieve best
signal transfer.
Figure 3
31