Reely SKY Thunder Bedienungsanleitung Seite 33

Charging via USB cable:
To avoid unnecessary strain on the batteries in the
transmitter, you may also charge the helicopter's flight
battery using the included USB cable (1).
Connect the plug connector of the USB charge cable,
which is protected against polarity reversal, to the
charging socket of the helicopter.
Connect the USB plug (2) of the charging cable to a
computer or notebook.
If the red control LED (3) for the charger electronics in
the USB plug lights up, the charging process is
completed and the charging cable can be removed from
the helicopter and computer.
For photo-technical reasons, the USB charging cable is illustrated in the wound-up state. Before first use,
the cable retainer should be opened and the cable unwound.
Do not connect the charging cable to a USB hub without a separate mains adapter (e.g. a keyboard USB
port, etc.), because these will not provide sufficient current for charging.
The operating system does not recognize any new hardware after connection, because the USB port is
only used for power supply.
Please observe that the USB ports of your computer/notebook are usually only active when the computer/
notebook is switched on.
Therefore, we recommend to only connect the charging cable to a computer/notebook that is switched on.
Figure 5
33