Distributing Firmware; Inserting The Lettering Label - Auerswald COMfortel 1600 Installationsanleitung

Further Steps
– Once you have carried out the firmware update, you can distribute this new
firmware version from this telephone to all the other system telephones of
the same design connected to the PBX.
Note: If there are system telephones of different designs, an additional
manual firmware update is necessary for each design.
– In order to use new features after a firmware update, you usually need a
new version of the COMfortel Set configuration software as well as a new
version of the Operation Guide. Both can be found in the internet (see
www.auerswald.de/service).
– In order to use the new features after a firmware update of the telephone,
an update of the PBX firmware is often necessary (see instructions of the
PBX).

Distributing Firmware

Note: If there are system telephones of different designs, the firmware has
to be distributed for each design.
Requirements
– New firmware version on the distributing telephone
1.
Press the menu key.
2.
Tap successively on settings > synchronisation > distr. firmware.

Inserting the Lettering Label

Requirements
– Lettering label. On
labels that can be cut out and labelled manually. Using the COMfortel Set
configuration software, you can easily create and print your lettering labels
(page Function keys > Print button).
– A flat tool (for example, a small flat-head screw driver)
COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V06 05/2015
The firmware is distributed. During the distribution process, Server
Mode is displayed on the distributing telephone. It is not possible to use
the telephone during this process.
page 65 of these instructions, you will find lettering
Appendix
55