Herunterladen Inhalt Inhalt Diese Seite drucken

Auerswald COMfortel 1600 Installationsanleitung Seite 43

Systemtelefone
Vorschau ausblenden Andere Handbücher für COMfortel 1600:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

A power supply type no. FW7577/EU/40
The mounting hardware accompanying the key extension modules (special
fasteners, screws, and connection cable)
A screw driver (Phillips)
Telephone switched off (disconnected from the 230 V power supply – if
available – and disconnected from the PBX)
Telephone and key extension modules adjusted to the required height
1.
Place the telephone and the key extension modules on the table in the po-
sition in which they are to be assembled.
Note: The key extension modules (up to three are possible) are assembled
at the right side of the telephone.
2.
Rotate the telephone and key extension modules so that the lower side is
in front of you.
3.
Insert the narrower connector (RJ-10) of the connection cable into the
socket labelled with
4.
Insert the wider connector (RJ-11) of the connection cable into the socket
labelled with
5.
Install the connection cables in the neighbouring cable channels in such a
way that you can assemble the special connector without obstructions.
6.
Combine the components with the help of the special connector and fasten
the special connector with two screws.
Note: Only hand-tighten the screws. The key extension modules will be
slightly loose after mounting, to compensate for any unevenness in the sur-
face on which they are being installed.
7.
Additional key extension modules: insert the narrower connector (RJ-10) of
the connection cable into the socket labelled with
the key extension module connected previously.
8.
Insert the wider connector (RJ-11) of the connection cable into the socket
labelled with
9.
Repeat steps 5. and 6. for the connected key extension modules.
10.
Remove the bridge plug from the socket labelled with
of the telephone.
11.
Insert the RJ-45 connector of the power supply into the socket labelled with
COMfortel 1600/2600 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V06 05/2015
on the lower side of the first key extension module.
on the lower side of the next key extension module.
on the lower side of the telephone.
on the lower side of the telephone.
Preparation
on the lower side of
on the lower side
43

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Comfortel 2600

Inhaltsverzeichnis