Ddlm_Set_Prm Operating Parameters; Diagnostic Information - SICK DME 3000-2 Betriebsanleitung

Page 46

10.1.4 DDLM_Set_Prm Operating Parameters

Octet Bit Type
9 0 bool
1 bool
2 bool
3 bool
4 bool
5 bool
6 bool
7 bool
Because the DME 3000 is a linear encoder, which measures the absolute distance between the
material scanned and the sensor, the "Code Sequence" and "Scaling function control" parameters are
ignored.
The "Class 2 Functionality" must be set to '0' if the diagnosis data described below should be
compatible with Class 1.
Class 2 Commissioning
Functionality Diagnostic
x
0
1

10.1.5 Diagnostic Information

7 Octed string
8 unsigned 8
9
0 bool
1 bool
2 bool
3 bool
4...7 bool
10 unsigned 8
11...14 unsigned 32
15...16 unsigned 16
The bits 0...7 from Octed 8 are set fixed to "0". Octed 9 of the diagnosis data reflects Octed 9 of the
transmitted parameter data.
The values for the encoder type "Measuring Step in nm" and "Distinguishable revolutions" are fixed.
The diagnosis data are only transmitted if a fatal error occurs in the DME.
Output
Code Sequenz (CW/XCW)
Class 2 Functionality (on/off)
Comissioning diag. (on/off), optional
Scaling function control
Reserved for future use
Reserved for future use
Reserved for manufacturer
Reserved for manufacturer
Length of the "Diagnostic Information"
0 6 Byte standard diagnosis
1 16 Byte Class 1 diagnosis data
1 61 Byte Class 2 diagnosis data
Extended diagnostic header
Alarms (not used)
Operation status
Code sequence status
Class 2 functionality supported
Commissioning diagnostics supported
Scaling function status
not assigned
Encoder type 00 ... FF
Singleturn resolution (rotary)
or Measuring Step in nm (linear)
Distinguishable revolutions
DME 3000-2 _ _P
Software 1.1
Default
0
7
1.000.000 nm
0