Menu Control; Main Menu; Parameter Setting For The Interfaces; Profibus - SICK DME 3000-2 Betriebsanleitung

DME 3000-2 _ _P
Software 1.1

4 Menu control

For the Menu overview see Page 43.

4.1 Main menu

The main menu offers the following options:
INTERFACE
SERVICE
RETURN

4.2 Parameter setting for the INTERFACES

The INTERFACE submenu offers the following options:

DISPLAY

OUT1
OUT2

PROFIBUS

AVERAGE
RESPONSE TIME
MODE
Note: The equipment parameters set via the menu only apply to equipment operation without
active Profibus. While activating the bus all parameters are downloaded from PLC to DME
(except Profibus address and Profile.
4.2.1 PROFIBUS
PROFIBUS
PROFILE
SICKPROF
ENCOPROF
PBADDR
Default setting
4.2.2 DISPLAY
This menu is provided for adjusting the display and the digital interface.
The display is updated with a cycle period of approx. 1 s.
Status as delivered:

4.2.2.1 OFFSET

Additive offset with effect on the measurement result display, the serial interfaces and the switching
outputs Q1 and Q2. The switching threshold setting is with respect to the value shown in the display.
Range:
Parameter setting for the interfaces
Commissioning aids, error displays
Return to current measurement reading display / Power On display
Alphanumeric display
Switching output Q1
Switching output Q2
Parameterizing Profibus slave address and profile selection
Average calculation
Sick Profile
Encoder Profile
Parameterizing of the profibus slave address
ENCOPROF
PBADDR. 6
OFFSET
- 016 383 mm ... + 032766 mm
Functional principle:
Switching outputs:
0 mm
Display = Profibus interface = Reading + Offset
LOW = Reading + Offset + 0,5 x Hysteresis < Limit
HIGH = Reading - Offset - 0,5 x Hysteresis > Limit
Page 31