Operating Mode - ZyXEL P-334WH Schnellstartanleitung

2 Accessing the Web Configurator
1 Launch your web browser. Enter "192.168.1.1" as the web site address.
Note: If the login screen does not display, check your browser's security settings (see
Troubleshooting for details) or make sure your computer is set to receive an IP address
dynamically (see
2 The Password window displays. Enter the
password ("1234" is the default) and click Login.
3 Change the password in the screen that follows
and click Apply.

3 Operating Mode

The P-334WH supports three operating modes: Router, Access Point and WiFi WAN Router.
Router (default): Select this mode if the P-334WH is connected to a broadband DSL/cable modem. NAT
allows all LAN computers to access the Internet using the same public IP address.
WiFi WAN Router: In this mode, the P-334WH works similarly as a Router, but uses a wireless WAN
connection via an access point (AP) or wireless router, instead of a wired connection via a DSL/cable modem.
In this mode, the P-334WH does not allow network access to wireless clients (WLAN).
Access Point: In this mode, the P-334WH works as a Router without routing features (such as NAT), firewall,
content filtering, etc.
Set Up Your Computer's IP
ENGLISH
Address).
4 Click Go to Wizard setup to set up your P-334WH
(in router mode) for the first time.
Click Go to Advanced setup to use main menus to
configure advanced features, such as operating
mode.
5