Conrad FS20 UTS Bedienungsanleitung Seite 56

Programming signal command:
2
1
or
2
1
2
1
Enter signal command
56
Channel 1
4
3
4 Channel 2
3
Press for 5 seconds
LED "D1" is lit
LED "D2" flashes
4
3
LEDs "D1" and "D2"
go out
• For channel 1 press the "1", "3" and "4"
buttons together for 5 seconds until the LED
"D2" flashes.
For channel 2, press the "1", "2" and "3"
buttons.
• Then enter the signal command in accordance
with the table on the preceding page:
• Once the signal command is entered the
LEDs go out.