H) Trimming In The Model Helicopter - Reely MSP190 Bedienungsanleitung

h) Trimming the Model Helicopter
First start the transmitter, then the model.
Push the pitch lever (also see figure 1, item 8) from the bottom position (engine off) carefully forward and observe the
response of your model.
Shortly before the helicopter starts hovering, you can already determine in which direction your model wants to
move.
Tail trimming:
If the helicopter wants to turn to the right with the tip of the fuselage, reduce the speed until the helicopter is standing
on its skids again safety, and then push the left one of the two trim buttons for the tail function (also see figure 1, item
7) repeatedly.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Keep repeating this procedure until
the helicopter no longer has any tendency to turn to the right.
If the tip of the fuselage turns to the left, press the right trim button for the tail function.
Every operation of a button is confirmed by a short signal sound. The set value for tail trimming is not saved
and must be re-adjusted after each activation of the remote control.
46
Figure 14