G) Practical Flight Advice For The First Start - Reely MSP190 Bedienungsanleitung

Nod Function
The nod function allows you to move your model helicopter forward and backward (see figure 13). This is also cont-
rolled with the right control stick (also see figure 1, item 3).
If you press the lever slightly forward, the model flies forward. If you pull the lever towards the back, the model flies
backwards.

g) Practical Flight Advice for the First Start

Even though the model can fly in the narrowest of spaces, for the first test flights we recommend using a free space
of about 3 x 3 m.
The support should be flat (tiles, parquet flooring, or similar) to allow you to determine even before take-off if the model
tends to drift off in a particular direction.
Place yourself exactly behind your helicopter. As long as you can see your model from behind, it will react to the cont-
rol commands: right, left, forward, backward exactly as you see it. Whereas, if the cockpit of the model points towards
you, it reacts exactly the opposite way from your steering commands at the transmitter.
Attention!
If the rotors hit any objects and are blocked or if the model falls over when standing, slide the pitch lever
(also see figure 1 item 8) into the bottom-most position at once so that the two drive motors are no longer
supplied with power.
Caution, important!
Never try grabbing the flying helicopter with your hand. There is an increased danger of injury!
Figure 13
45